View Single Post
Old November 23, 2018, 07:55 PM   #6
Scorch
Senior Member
 
Join Date: February 13, 2006
Location: Washington state
Posts: 13,555
If you use stripper on the stock don't get it on the plastic, it will damage the plastic and make it sticky. Simple solution- sand the finish off down to 400 or 600 grit. The plastic will be smooth and grayish black. When you put finish on the stock, wipe just a fine film of finish onto the plastic. This will create a glossy surface and restore the look.
__________________
Never try to educate someone who resists knowledge at all costs.
But what do I know?
Summit Arms Services
Taylor Machine
Scorch is offline  
 
Page generated in 0.02924 seconds with 8 queries