Thread: scope mounts
View Single Post
Old July 31, 2012, 05:17 PM   #2
Creeper
Senior Member
 
Join Date: September 9, 2008
Location: Woooooshington
Posts: 1,797
Talley makes excellent rings... IMO.

Do you mean the shoulders bottom out on the sides before the you reach the correct screw torque value?

No, that shouldn't happen... it might be really close, like a few thousandths gap, but not bottom out.
If that's the case, the scope may shift. You can shim them, but you shouldn't have to do that. Might be the scope... did you measure the scope and rings with, at least, a dial caliper?

Call Talley and see what they have to say.

Phone: (803) 854-5700
Fax: (803) 854-9315
Email: [email protected]

C
__________________
Shoulder Drive Nicholson Club
Creeper is offline  
 
Page generated in 0.04583 seconds with 8 queries