View Single Post
Old March 3, 2009, 03:04 PM   #11
Senior Member
Join Date: August 9, 2007
Location: Oregoncoast
Posts: 1,672
This is for the record, since people google for answers and here it is! I ordered a new bolt stop assembly (Not "bolt block" as stated earlier) as part # KA-37.
That's the blued model stop, as I'm hoping the carbon steel will hold up better to the battering it takes.
My fix on the original stainless part lasted about 5 boxes. Interestingly, conversing with the parts department at Ruger, the fellow said they don't carry the stainless part anymore (Part# KAN-37) to which I replied "Well, that's fine, you can't see it anyway". He also chuckled when I suggested the carbon steel part might hold up better, "That's been an argument around here for a while" he said.

I bought two of them for a total of $8 (plus shipping). That should last a while.
CNC produced 416 stainless triggers to replace the plastic triggers on Colt Mustangs, Mustang Plus II's, MK IV Government .380's and Sig P238's and P938's. Plus Colt Mustang hardened 416 guide rods, and Llama .32 and .380 recoil spring buttons, checkered nicely and blued.
HisSoldier is offline  
Page generated in 0.02976 seconds with 8 queries