|
Once you removed the bullet and powder the case didn't chamber , you would have to resize the case . Go back to the beginning , size , measure case length , trim if needed , chamfer inside and out . As others stated I hope your checking with a clean chamber . Setting up your sizing die to bottom out on the shellholder , remember to lube case body and around case neck lightly , I lube the inside of the necks also but that adds another cleaning step , try leaving the expander ball shaft slightly loose not locked down tight , will self center the expander when pulling through the neck , make sure the expander ball is set at the right height , see instructions . After all that I'm sure your cases will chamber.
Then after all that seat the bullet without a crimp and lower until it chambers forget about measuring for now let's see what it takes to chamber , DO THIS WITH OUT POWDER OR PRIMER , ONLY CASE AND BULLET.
|