View Single Post
Old November 18, 2011, 12:32 PM   #28
BigJimP
Senior Member
 
Join Date: February 23, 2005
Posts: 13,195
As you go to seat the barrel into the receiver ...retract the bolt an inch or so inside the receiver ( by holding back the bolt handle ) ...and move the bolt a 1/2" or so each way ...and push barrel into the receiver and it should seat.

A question like this would be best served to start a new thread ...not just on an older one / where noone might look at it - except by chance....like I did...
BigJimP is offline  
 
Page generated in 0.03795 seconds with 8 queries