View Single Post
Old December 7, 2019, 03:06 AM   #2
Scorch
Senior Member
 
Join Date: February 13, 2006
Location: Washington state
Posts: 15,248
No reason not to sand in pure tung oil. It just takes longer to dry than blended finishes.

I apply the first coat, let it dry about a week. Then use 400 or 600 grit wet/dry paper to wet sand the next 2 coats of oil (following the grain, not circling). Wipe off the excess each time so the finish does not get sticky. After this dries about a week, sand smooth, the wood will be filled. To complete the finish, apply thin coats of oil on top of the filled wood by putting a dab in your hand and spreading it over the entire stock.
__________________
Never try to educate someone who resists knowledge at all costs.
But what do I know?
Summit Arms Services
Scorch is offline  
 
Page generated in 0.02737 seconds with 8 queries