Thread: DIY Rifle Rest
View Single Post
Old June 24, 2008, 12:47 AM   #1
Sixer
Senior Member
 
Join Date: April 16, 2008
Location: Missouri
Posts: 1,891
DIY Rifle Rest

I have my mind set on a new project. I'm becoming more and more like my father every day... scary!

I would like to make my own rifle rest for use at the range. I dont need anything too fancy but I would like it to be adjustable and sturdy. I am looking for something that I could use to sight in or just clean my rifles with. I am not a metal worker or welder, so the plans need to be fairly simple. Inexpensive materials are a priority. I guess it would defeat the whole purpose by spending more on parts than it would cost to just buy one at the store. Here are a few links I was checking out just to give a visual.

http://www.benchmasterusa.com/
http://www.mtmcase-gard.com/products/shooting/pred.html
http://www.titegroup.com/beast62008.jpg

No way I can whip up any of these in my garage, but Im hoping you guys may have some advice on where to start or some experience of your own you would be willing to share! Thanks
Sixer is offline  
 
Page generated in 0.02935 seconds with 8 queries