From what I've read about Uberti revolvers, the short arbor issue does pop up a lot, that said.. they may have already taken steps to remedy the issue. Some of the reports online are from a while back.
It should be part of your checklist when you get the revolvers, so I suspect any issues could be taken care of by the manufacturer. If not, I've read everything from shims to JB Weld to fit to the arbor. Also Mike, 45 Dragoon, does a great tune up that allows you to adjust the fit with a screw (I think), among many other improvements.
Last edited by JACKlangrishe; January 15, 2017 at 01:30 PM.
|