The Firing Line Forums - View Single Post - Pre-64 300 H & H Magnum

Jim Watson · November 1, 2012, 10:10 AM

Actually, not, Jimro. That is a knockoff of a Unertl target scope. At one time you could get bases for it that would fit the receiver ring and rear sight dovetail. So it could be made to work if you could find those bases.

What I referred to was like the one advertised here:
http://www.ebay.ca/itm/Bear-Cub-Mast...item27cc5611aa

It uses the receiver ring holes and the left side peep sight holes.
There is also a version that has a long sleeve that goes over the objective end and sets in the open sight dovetail.

November 1, 2012, 10:10 AM	#10
Jim Watson Senior Member Join Date: October 25, 2001 Location: Alabama Posts: 18,539	Actually, not, Jimro. That is a knockoff of a Unertl target scope. At one time you could get bases for it that would fit the receiver ring and rear sight dovetail. So it could be made to work if you could find those bases. What I referred to was like the one advertised here: http://www.ebay.ca/itm/Bear-Cub-Mast...item27cc5611aa It uses the receiver ring holes and the left side peep sight holes. There is also a version that has a long sleeve that goes over the objective end and sets in the open sight dovetail.