View Single Post
Old December 14, 1999, 01:51 PM   #1
WinMag
Member
 
Join Date: November 12, 1999
Posts: 49
My Millet rings came with what looks like hard rubber shims with an adhesive backing. It almost looks like they would fit inside the rings. I have a 10/22T with a 6-24x44AO, and need to shim my scope to raise my point of impact. If I put one of these on the rear ring only (inside), would it cause undue stress on the scope body when I tighten it down since the front one does not have one? Or are these things designed to go in the rings (both front and back) to protect the scope body from scratches...etc? OR, are these things designed to go under the scope base between the reciever?

Thanks,
WinMag
WinMag is offline  
 
Page generated in 0.04513 seconds with 8 queries