The Firing Line Forums - View Single Post

wiiawiwb · August 23, 2015, 06:06 PM

The shaft is turning just fine. It's the rubber sheath on top that should be "glued" to the shaft and isn't. So, as the shaft turns, the rubber sits there.

I think what i need to do is to somehow remove the shaft, then remove the rubber sheath and clean then both and make sure whatever that is inside and gone. Maybe even glue the sheath to the shaft.

I looked at it for about 15 minutes and couldn't figure a way to do it.

August 23, 2015, 06:06 PM	#3
wiiawiwb Member Join Date: February 20, 2012 Posts: 52	The shaft is turning just fine. It's the rubber sheath on top that should be "glued" to the shaft and isn't. So, as the shaft turns, the rubber sits there. I think what i need to do is to somehow remove the shaft, then remove the rubber sheath and clean then both and make sure whatever that is inside and gone. Maybe even glue the sheath to the shaft. I looked at it for about 15 minutes and couldn't figure a way to do it.