The Firing Line Forums - View Single Post - I'm Going to Make Aluminum Ratchet for my Lee 4 Hole Turret Press!

dickttx · August 21, 2012, 08:04 PM

Several thousand rounds over the past two/three years and still on the same one.
The handle and toggle system will put lots of pressure on things. If you put the pressure on at the wrong time the 50¢ piece breaks, rather than messing up your whole press.
You do use breakers in your electrical system don't you? Some people used to put a penny in the hole when glass fuses were used. Some didn't get out alive when the fire started.

August 21, 2012, 08:04 PM	#6
dickttx Senior Member Join Date: May 29, 2011 Location: Fort Worth Posts: 500	Several thousand rounds over the past two/three years and still on the same one. The handle and toggle system will put lots of pressure on things. If you put the pressure on at the wrong time the 50¢ piece breaks, rather than messing up your whole press. You do use breakers in your electrical system don't you? Some people used to put a penny in the hole when glass fuses were used. Some didn't get out alive when the fire started. __________________ Education teaches you the rules, experience teaches you the exceptions (Plagiarized from Claude Clay)