The Firing Line Forums - View Single Post

croc4 · January 13, 2009, 12:10 AM

I have a second hand Stainless Dan Wesson .357 that I picked up many years ago, it was a good deal so could'nt pass it up. Anyway around the firing pin hole there is a small divet, its not very big or deep, but when fired the primers show a noticable raised bump. Is there something that can fill or correct this? without replacing the frame?

Croc4

January 13, 2009, 12:10 AM	#1
croc4 Senior Member Join Date: March 9, 2006 Location: Idaho Posts: 191	Dan Wesson help I have a second hand Stainless Dan Wesson .357 that I picked up many years ago, it was a good deal so could'nt pass it up. Anyway around the firing pin hole there is a small divet, its not very big or deep, but when fired the primers show a noticable raised bump. Is there something that can fill or correct this? without replacing the frame? Croc4