Thread: TiteGroup
View Single Post
Old July 12, 2001, 08:23 AM   #8
Tree Rat
Senior Member
 
Join Date: February 7, 2000
Posts: 138
Okay..thanks Alleycat. I'll bump up the load in 45 and see what I get. Interesting your experiences with Clays. The only reason I looked to TiteGroup (other than being curious) was I wanted to reduce presure with a somewhat slower powder which TiteGroupd does. Since the two are similar in burn rates, I was just surprised to see that much burned or unburned junk from mid range loads. Incidently, switched back to a mid range HP38 load with an even slower burn rate, and it was much cleaner, with only some specs on the white shirt I was wearing when shooting. I guess I'm puzzled here because I thought lower pressure cartridges like 45ACP and 38 special worked better with faster powders. Slower powders had more tendancy to dirty up or burn inefficiently when not presured up. Universal Clays does this but really shines in high pressure cartridges like 9mm and .40S&W. I'm learning. Tree Rat.
Tree Rat is offline  
 
Page generated in 0.02106 seconds with 8 queries