View Single Post
Old September 7, 2017, 06:43 AM   #1
Aguila Blanca
Staff
 
Join Date: September 25, 2008
Location: CONUS
Posts: 18,434
Revolver locking notches

I have a replacement cylinder for an Italian SAA clone that was begun for me by an older machine shop owner who was a Vietnam veteran. Unfortunately, he became ill and had to close down his shop before the cylinder was completed. What's left to do is deepening the notches for the bolt to lock into.

I can't find any information on the correct dimensions for these notches (radius of cutter, and depth and width of cut). Even if I had the information, I doubt it's anything I could accomplish at home. But with the information I might be able to find a local shop that could handle it. Does anyone have this information?

Second question: can anyone recommend a revolver gunsmith who is qualified to do this?
Aguila Blanca is offline  
 
Page generated in 0.03417 seconds with 8 queries