The Firing Line Forums - View Single Post

david_r · January 13, 2013, 01:43 AM

Can you seat ten bullets into unprimed brass and measure and then fcd them and measure? Low neck tension and compressed powder could push then back out I would think

Were your old bullets also .358?

What happens with your old dies and these new bullets? What happens when you set the new dies to the oal of the old ones and load?

January 13, 2013, 01:43 AM	#21
david_r Senior Member Join Date: January 9, 2013 Posts: 131	Can you seat ten bullets into unprimed brass and measure and then fcd them and measure? Low neck tension and compressed powder could push then back out I would think Were your old bullets also .358? What happens with your old dies and these new bullets? What happens when you set the new dies to the oal of the old ones and load?