The Firing Line Forums - View Single Post - Polymer Front Sight on Saint Pistol in .300 BLK?

FrankenMauser · February 12, 2019, 03:59 PM

If you're talking about the standard free float tube SA puts on the Saint 'pistols', you'll be fine. (As long as you're not doing mag dumps and overheating the firearm, anyway.)

Gas block = could be a problem.

I'm not sure where they went. Perhaps they were on a rifle that I sold... But I had some of the early Magpul knock-offs from ... Tapco(?). I actually preferred those plastic sights to standard sights, and even some aftermarket options. They were cheap and looked the part, but worked very well.

February 12, 2019, 03:59 PM	#5
FrankenMauser Senior Member Join Date: August 25, 2008 Location: In the valley above the plain Posts: 13,424	If you're talking about the standard free float tube SA puts on the Saint 'pistols', you'll be fine. (As long as you're not doing mag dumps and overheating the firearm, anyway.) Gas block = could be a problem. I'm not sure where they went. Perhaps they were on a rifle that I sold... But I had some of the early Magpul knock-offs from ... Tapco(?). I actually preferred those plastic sights to standard sights, and even some aftermarket options. They were cheap and looked the part, but worked very well. __________________ Don't even try it. It's even worse than the internet would lead you to believe.