View Single Post
Old August 5, 2013, 12:08 PM   #19
Palmetto-Pride
Senior Member
 
Join Date: May 31, 2009
Location: Charleston, SC
Posts: 2,071
If you are planning using the Trigger Adjuster like I did to get rid of some of the travel all you have to do is take the factory grip screw out and replace it with the Trigger Adjuster grip screw, but make sure the small screw is backed into the bigger grip screw and tighten it the way you would the factory grip screw then what I did was cock the hammer put it on safety and tighten the adjuster screw until I felt resistance from the safety being on (another words when the safety is on, the trigger has zero movement if you were to try and pull it) I did multiple safety checks to make sure the hammer wouldn't accidentally drop.
__________________
“The problem with socialism is that you eventually run out of other people's money.”

-Margaret Thatcher-
Palmetto-Pride is offline  
 
Page generated in 0.03894 seconds with 8 queries