Quote:
There's no way you could chuck a case in a drill press, then run a case against a cutter.
|
That is exactly what I did in the photos on page 1 just to see if it would work and it did on the 44 mag case shown in the photos. I used a TiN coated HSS end mill shown in the first photo. You don't need carbide to turn .008 off of a brass case but you could use it for sure.
If you only have 50 to do pack them up in a flat rate box and ship them with a drawing of what you want turned and enough money for a case of adult beverages and return shipping to you and I'll knock them out for you. PM me if you are interested.