The Firing Line Forums - View Single Post - Modify T/C's Armour Alloy barrel to standard Contender?

George Stringer · November 27, 1999, 08:55 AM

Kernel, I thought it was only a finish but you never know. The only "bad" possibility of enlarging the hole the way you're planning is the chance of getting it out of round or too big. If you don't have a smith near you take the barrel only down to your local machine shop. They should be able to ream the hole to the specific size you need. George

November 27, 1999, 08:55 AM	#4
George Stringer Staff Alumnus Join Date: October 12, 1998 Location: Earlington KY Posts: 2,299	Kernel, I thought it was only a finish but you never know. The only "bad" possibility of enlarging the hole the way you're planning is the chance of getting it out of round or too big. If you don't have a smith near you take the barrel only down to your local machine shop. They should be able to ream the hole to the specific size you need. George