The Firing Line Forums - View Single Post

Blindstitch · March 31, 2014, 01:34 PM

Last week I ordered some privi partizan brass for 6.5 Jap from Huntington Die Specialties and when priming them I learned that about 25% wouldn't fit in the shell holder. I ended up using a 30-30 shell holder to load the ones that wouldn't work.

I'm using Lee shell holders and have two for 6.5 and they both act the same.

I emailed Huntington and the reply I got back was:
These will fit an RCBS shell holder just fine. Ask Lee to fix his shell holders.

Has anyone else had experience with this. Norma brass fits these shell holders just fine.

March 31, 2014, 01:34 PM	#1
Blindstitch Senior Member Join Date: April 14, 2013 Location: Milwaukee, Wisconsin Posts: 2,693	Privi Partizan brass wont fit Last week I ordered some privi partizan brass for 6.5 Jap from Huntington Die Specialties and when priming them I learned that about 25% wouldn't fit in the shell holder. I ended up using a 30-30 shell holder to load the ones that wouldn't work. I'm using Lee shell holders and have two for 6.5 and they both act the same. I emailed Huntington and the reply I got back was: These will fit an RCBS shell holder just fine. Ask Lee to fix his shell holders. Has anyone else had experience with this. Norma brass fits these shell holders just fine.