i may have found my primer issue in the s&b brass , when resizing/removing the primers the pin for removing the primer is actually slighly larger then the hole in the bottom of the case so its pushing some brass up into the bottom of the primer pocket , my die set uses the small pin as well.
this also explians why ive broken a few pins with the s&b brass
i caught it this morning when i decided to go ahead and deprime/size all the brass i had , theres no additional resistance on the press over normal which i dont understand. but i noticed it when i was checking every case for lenght with my calipers.it doesnt do it in every case it was about 40% of the brass it was doing it to
im going to carefully clean up the burrs in the primer pockets and see what happens, my brownells order gets here today so ill have some small primer brass to try out as well
|