The Firing Line Forums - View Single Post

Hammer It · March 21, 2013, 03:17 PM

Hello
I would Prefer Marlin to come out with The Federal .327 Magnum in a Bolt rifle. I feel a Bolt rifle would be supreme as far as accuracy Goes with Marlin's Mico-Groove rifling and a Good Piece of Glass Parked on it it would make a Hell of a Woodchuck Gun, I would even use it for Deer up to 50 Yards It would be a Tack driver for that Task... I have a Nice Vintage Marlin 883 chambered in .22 W.M.R. That Pretty Much shoot's One Ragged hole if I do my Part right as shown below, This Target was shot at the 100 Yard Line using CCI-Maxi Mag ammo, sighting it in. The Last Three shot's were dead center and one Ragged hole. It is Tube fed with a 3-9 scope Parked on it. I would Love the same gun chambered in 327 Magnum...

Hammer it

March 21, 2013, 03:17 PM	#843
Hammer It Senior Member Join Date: December 8, 2004 Location: The Great Smoky Mountain Range Posts: 1,367	Hello I would Prefer Marlin to come out with The Federal .327 Magnum in a Bolt rifle. I feel a Bolt rifle would be supreme as far as accuracy Goes with Marlin's Mico-Groove rifling and a Good Piece of Glass Parked on it it would make a Hell of a Woodchuck Gun, I would even use it for Deer up to 50 Yards It would be a Tack driver for that Task... I have a Nice Vintage Marlin 883 chambered in .22 W.M.R. That Pretty Much shoot's One Ragged hole if I do my Part right as shown below, This Target was shot at the 100 Yard Line using CCI-Maxi Mag ammo, sighting it in. The Last Three shot's were dead center and one Ragged hole. It is Tube fed with a 3-9 scope Parked on it. I would Love the same gun chambered in 327 Magnum... Hammer it __________________ "Yeah, though I walk through the Valley of the Shadow of Death, ... I shall Fear no Evil, as I carry with me My Loaded S&W"..