View Single Post
Old October 10, 2013, 08:25 PM   #17
armoredman
Senior Member
 
Join Date: May 22, 2007
Location: Arizona
Posts: 5,295
Low cost is Lee dies and a Lee push through sizer. I use both for 9mm. I use both Lee molds, and find they both work well. Lee molds are not long lived - you probably won't pass them down to your grandkids. Lee equipment is just fine, and the Push Through .356 sizer just happens to come with a bottle of Lee Liquid Alox for tumble lubing, which works just fine as well. I prefer pan lubing the Lee 125 single lube groove 9mm bullet with a buddy's custom lube of alox and beeswax - whole place smells like warm honey while I'm lubing.
You can make many, many, many good quality bullets cheaply with your Lee dies and Lee sizer - I know that for a fact.
armoredman is offline  
 
Page generated in 0.03796 seconds with 8 queries