The Firing Line Forums - View Single Post

ZeroJunk · October 15, 2006, 07:34 PM

Would be good if you could post a picture.Some factory loads will actually flatten the primer somewhat.If it is bad enough there will not be any of the rounded edge of the primer visible and the firing pin indentation will be cratered.So ,it depends on what you call flattening.

October 15, 2006, 07:34 PM	#2
ZeroJunk Senior Member Join Date: August 14, 2006 Location: Browns Summit NC Posts: 2,589	Would be good if you could post a picture.Some factory loads will actually flatten the primer somewhat.If it is bad enough there will not be any of the rounded edge of the primer visible and the firing pin indentation will be cratered.So ,it depends on what you call flattening.