View Single Post
Old April 22, 2013, 09:17 AM   #8
myfriendis410
Senior Member
 
Join Date: March 30, 2011
Location: Lompoc California
Posts: 274
You could "Beagle" your mold. Take some aluminum tape (heating/ducting tape), cut a couple of strips and place them on either side of the casting void of your mold on one half only. You will need to clean the mold surface so the adhesive will stick and it will eventually fall off, but you can add several thousands to your mold diameter by doing this. I've done it and it works quite well. Try Googling "beagle molds" and see what pops up.
myfriendis410 is offline  
 
Page generated in 0.04350 seconds with 8 queries