View Single Post
Old September 6, 2021, 01:43 AM   #13
Join Date: February 12, 2001
Location: DFW Area
Posts: 24,022
I purchased the special screwdriver tip from Brownells to make disassembly possible. I know, I know, everyone can do this without any special screwdriver tip, but I'm stupid.
I have the screwdriver too, but I've never needed to use it.

You never need to disassemble the cylinder to that level just to clean the gun. In fact, by the time you can even access that screw, you're already well past the level of disassembly that Ruger recommends. Certainly beyond the level required for cleaning.
Do you know about the TEXAS State Rifle Association?
JohnKSa is offline  
Page generated in 0.02063 seconds with 8 queries