The Firing Line Forums - View Single Post - Recommendation for machining brass casings

hpg · September 13, 2010, 01:10 PM

If you can't do this yourself, I would suggest you pass on the whole idea. The cost would be way too much......

......hpg

September 13, 2010, 01:10 PM	#11
hpg Senior Member Join Date: September 14, 2002 Location: in the Bluegrass State Posts: 1,610	If you can't do this yourself, I would suggest you pass on the whole idea. The cost would be way too much............hpg __________________ NRA member Semper Paratus