The Firing Line Forums - View Single Post

blackopsglock · December 28, 2007, 12:14 AM

Simple solution

the factory supplied rod comes apart easy by heating the brass end up with a torch.Its held on by glue.

Remove cut the ramrod and reglue

I sell aluminum rods cut to fit any application.Hollar if you need one.

December 28, 2007, 12:14 AM	#12
blackopsglock Member Join Date: October 6, 2002 Posts: 51	Simple solution the factory supplied rod comes apart easy by heating the brass end up with a torch.Its held on by glue. Remove cut the ramrod and reglue I sell aluminum rods cut to fit any application.Hollar if you need one.