View Single Post
Old November 27, 2012, 10:43 AM   #1
Wallyl
Senior Member
 
Join Date: September 8, 2011
Posts: 255
Carbide sizer die wear

I have a Lyman .38 Cal carbide sizer die that I've had for over 30 years---I have noticed that on some .38 Spl cases bullets sized to .358" go into the cases quite easily and that my expander die goes into the case with little pressure...could the carbide sizer ring have worn down on it? As it is so hard, it's hard to believe that it woudl do so....yet? This does not happen with .357 Mag cases or .38 Spl Military brass as the cases are thicker.
Wallyl is offline  
 
Page generated in 0.03722 seconds with 8 queries