View Single Post
Old August 11, 2009, 08:32 PM   #2
Farmland
Senior Member
 
Join Date: July 5, 2009
Posts: 869
296 can bind the powder measure. I have had some problems. I know if your measure is well used it can be a bigger problem. I had called Dillon when mine really got bad and they sent me a new powder measure for free. That was a few years ago.

Oh I forgot to add the workaround it has been some time since I had to do this.The next time you empty the measure of powder, remove the small powder bar and spacer. Measure the vertical thickness of both. It should measure .357"-.359". You can build up or thicken the top of the spacer by putting a piece of tape on the top of the spacer. This will decreases the gap between the bar and spacer so the powder can't get between them.

Last edited by Farmland; August 11, 2009 at 08:46 PM.
Farmland is offline  
 
Page generated in 0.02047 seconds with 8 queries