Here is picture of top part of the
first scale-up model, next to smaller
Wickliffe. It has 12GA FH round in feed
trough. It is aluminum just for a model.
It will handle 12GA FH, 700HE, 700NE, 600NE,
etc. Bottom of block is flat to set on
mill table to do the machining.Next machining
will be the hole and slot down through the
action for breech block and hammer to
slide up and down in.Its taken awhile to
get some tooling.I had none when we set up
vertical mill. Anyone with some surplus long
end mills and R8 tooling, holders,big drills
let me know. I need a bargain on some.Ed.