View Single Post
Old February 5, 2021, 08:48 AM   #10
Grey_Lion
Senior Member
 
Join Date: April 15, 2018
Location: Baton Rouge - Louisiana
Posts: 366
I've sworn off ALOX as it gunked up so much of my gear even when I carefully and selectively applied it to just the lube groves ( i.e. didn't coat the entire round ) With that said, if you're not going to go into cast rounds beyond these 250 projectiles, don't invest in anything you don't already have - it's just not worth it. If you are going to go further into cast lead, get a cheap toaster oven at your local thrift store and watch 5 to 10 powder coating youtubes, then get into powder coating your cast rounds. Only thing else you'll need is a sizing die for the cast rounds and powder coated rounds.
Grey_Lion is offline  
 
Page generated in 0.03061 seconds with 8 queries