View Single Post
Old January 16, 2021, 05:54 PM   #1
BJung
Senior Member
 
Join Date: December 5, 2019
Posts: 769
PC rubbing off bullet observation and solution

I pulled a few 45-200LSWC bullets yesterday using my kinetic puller and noticed than all of them had the pain rubbed off. If such is the case, the exposed lead would rub off in my barrel. I took a hammer and smashed a bullet with a hammer, even at an angle and the pain remained on the lead without chipping off. I am thinking that maybe I should lube the bullets before seating them. Any opinions?
BJung is offline  
 
Page generated in 0.03166 seconds with 8 queries