View Single Post
Old August 29, 2020, 09:07 AM   #12
big al hunter
Senior Member
Join Date: March 12, 2011
Location: Washington state
Posts: 1,543
It appears that your bullets don't have powder coat on the bottom. If that is the case, the company you purchased them from is using a powder coat gun and baking them on the same sheet they coated on. When they remove the bullets there are little edges of coating sticking out. They break off when sizing or packaging the finished bullets. They probably solved that issue as they progressed.
You can't fix stupid....however ignorance can be cured through education!
big al hunter is offline  
Page generated in 0.02958 seconds with 8 queries