View Single Post
Old August 28, 2020, 05:55 PM   #9
ghbucky
Senior Member
 
Join Date: June 12, 2020
Posts: 745
To make it clear, I don't think the coating is coming loose.

Here's a pic of a couple of the cast bullets. These are more on the extreme side. Usually what I'm seeing is a small spot of exposed lead, like where a sprue was?

Again, I have never cast a bullet, but when I look at this it makes me think there was excess lead that wasn't trimmed, powder coated, and then run through a sizer/swager that stripped off the excess.

These are 135gr 9mm.
Attached Images
File Type: jpg IMG_0185.jpg (814.0 KB, 35 views)
ghbucky is offline  
 
Page generated in 0.03251 seconds with 9 queries