View Single Post
Old September 20, 2018, 03:29 PM   #8
token24a
Junior Member
 
Join Date: September 18, 2018
Posts: 4
The history surrounding firearms is fascinating. Thanks again to everyone who has shared insight on this. I'm not expecting to have a definitive answer as to when and where this came from but I am hoping to at least narrow it down.

Jim Watson I'll have to see if I can find those catalogs online to look through them.

T. O'Heir great input on the country of origin stamps on barrels. So it sounds like quality would vary greatly from shop to shop which would explain a rougher fit and finish and why it may or may not have a makers mark?

arcticap: using a tape measure I got 7/16" bore size, or 0.4375". 11mm ball?
token24a is offline  
 
Page generated in 0.03032 seconds with 8 queries