View Single Post
Old September 14, 2020, 10:06 AM   #7
Grant 14
Senior Member
 
Join Date: February 10, 2018
Posts: 118
Hi Jim, my trigger set up is complete and is a single set. There is not too much that I really need other than the previous mentioned parts. The next big expense will be getting the liner installed in the barrel and getting the rimfire extractor groove welded up because the center fire extractor is much smaller. I know a very good machinist that will do that part for me. I have Fagen semi inletted/semi fancy wood for it, so there will be lot of hand work, but that is fine. If you happen to run across other parts, I might be interested, just for spares. Thanks, Grant.
Grant 14 is offline  
 
Page generated in 0.02770 seconds with 8 queries