View Single Post
Old January 21, 2013, 08:57 PM   #20
Senior Member
Join Date: April 20, 2009
Location: Helena, AL
Posts: 3,717
My .02

I've loaded the 7mm Remington for 40 years and never had a case, primer, or pressure problem until the case was discarded after about 5-7 maximum loads. Per Ken Waters, as soon as I saw primer flattening, or more than .005 increase in head measurement, I would back down .5 grain. The primer pocket "prolapse" was the usual culprit. I was taught to full size the case when new; then, place a nickel between the shell holder and the die. The belted cases head space on the belt, so any additional working of the brass accelerated insipient head separation.
GeauxTide is offline  
Page generated in 0.03104 seconds with 8 queries