View Single Post
Old January 16, 2009, 01:46 AM   #4
scout7
Junior Member
 
Join Date: December 31, 2008
Posts: 4
Thanks for the reply. It has a fixed modified choke on the plain (no rib) barrel. I was thinking of setting the gas ring very light and then shooting target loads, slowly tightening up the ring until I get it to eject and reload the chamber.

I have read about the fragile action bar and the fact that it can hit the stock mounting piece. Is this piece visible with the trigger group out? I want to make sure that the action bar will not hit it, what I read said that it was common to break the action bar after the buttstock was removed and replaced. The stock mounting piece seems to rotate into the path of the action bar which causes damage the first time it is fired after re-assembly.

Does this seem correct?
scout7 is offline  
 
Page generated in 0.03391 seconds with 8 queries