View Single Post
Old January 10, 2019, 01:51 PM   #11
UncleEd
Senior Member
 
Join Date: April 13, 2013
Location: N. Georgia
Posts: 1,150
Like poster Bill DeShivs, I don't see
any pry marks, i.e. the thin "lip" of the
plate distorted.

Try loosening screws and resetting plate.
Or gently tapping plate to see if it seats
and screws need tightening.

It's possible that something like the hammer
block, trigger return block or hammer is not
quite seated properly.

The picture provided by the broker shows
the plate isn't seated flush/properly.
UncleEd is offline  
 
Page generated in 0.03902 seconds with 8 queries