View Single Post
Old December 9, 2005, 09:57 AM   #36
Steve499
Senior Member
 
Join Date: December 14, 2004
Location: Central Missouri
Posts: 533
I've been puzzling about your bright spots, Dragoon. I'm guessing there was a tighter place in the bore which was wearing those places but how do you suppose they came to be tight? I haven't taken either the front sight or the rammer latch off of mine, don't know if they are threaded or what but it would seem to have taken a pretty good blow to the bottom of the hole to have caused that. I'd be curious to know what processes Pietta uses to drill the holes and install the sight and latch. I think I've got what you are intending to do. You are going to work the piece of barrel down into a dovetail around the latch and then put it into a dovetail you have cut into the shortened barrel. I would be interested to know how close the bottom of the hole is to the grooves inside the barrel if it works out you have to remove enough metal to tell.


Steve
Steve499 is offline  
 
Page generated in 0.02813 seconds with 8 queries