|
Seamaster,
Yes, as part of trying to see what the cause is, I've run the plate both a touch tight, and a touch loose from what I'd call the normally successful adjustment and had issues on both sides of the zero point of adjustment. Also slowed my press cycling down (but don't think I run the press fast to begin with).
I plan to tinker with it more this evening and start with case insertion slide lube, double check spring adjustment on primer assy.
In reviewing the issue, and comments you guys were nice enough to make, I'm realizing that I've probably been slow to re-lubricate the press. Honestly I haven't lubed anything in the 4 months I've had it.
|