View Single Post
Old January 16, 2019, 09:00 AM   #83
cw308
Senior Member
 
Join Date: September 2, 2010
Location: Plainview , Long Island NY
Posts: 3,863
Metal
The artical from Precision Shooter covered all . It comes down to removing the slop , then again it comes down to how far down do you screw the die to the point of stress . I guess some will adding to much and some not enough , not enough and seeing light between shellholder and die with the case sized in the die will show not enough slop is removed . It's when to much is set up .

I use the Competition Shellholders and set up to remove slop not over tighten , it's by feel and I guess it comes down to , hard to some is not enough , alittle more is better. Like you listed your measurements will let you know. Thanks Again , made good reading but the battle I can see will still go on .

Chris
cw308 is offline  
 
Page generated in 0.02353 seconds with 8 queries