View Single Post
Old January 15, 2019, 06:05 PM   #78
F. Guffey
Senior Member
Join Date: July 18, 2008
Posts: 6,780
The shoulder measuring makes it quicker and a bit easier.
So you do not know the distance from the shoulder in the die to the deck of the shell holder? And you do not know if the case won or the press won? And you do not know how to increase the presses ability to overcome the case's ability to resist sizing? and then there is that gap between the bottom of the die and top of the shell holder?

F. Guffey
F. Guffey is offline  
Page generated in 0.04728 seconds with 8 queries