Thread
:
Is it feasible to [i]make[/i] a muzzle brake in a home shop?
View Single Post
September 25, 2001, 03:03 PM
#
8
weagle
Senior Member
Join Date: September 4, 2001
Location: atlanta GA
Posts: 107
Clead, As I mentioned, I'm totally uneducaded when it comes to machining. I would think you could use most any method that would leave you with good even rifleing at end. After all the overbored portion is not going to contact the bullet.
weagle
View Public Profile
Find More Posts by weagle
Page generated in
0.01954
seconds with
8
queries