Thread: Type 38 project
View Single Post
Old June 18, 2017, 08:54 PM   #4
JT-AR-MG42
Senior Member
 
Join Date: December 27, 2008
Posts: 510
Lots of 38s have been parted out over the years, so it will just
take patience to round them up.
If the bore is shootable, go for it.
Stock shown looks clean without having been sanded down.

I'm thinking floorplate assembly, upper tang, tang and stock screws, upper and lower bands, and of course, the bolt.
Recommend you find a complete bolt if possible, rather than putting one together from parts. Less chance of issues with the safety.

Maybe share a pic of the left receiver markings.
Is it a series rifle or a straight Koishikawa?
Put a piece of blue tape over a couple of the serial numbers if you feel the need.

Good hunting, JT
JT-AR-MG42 is offline  
 
Page generated in 0.02882 seconds with 8 queries