View Single Post
Old January 13, 2021, 06:34 PM   #7
Join Date: March 4, 2005
Location: Ohio
Posts: 18,434
I know people upset cast bullets to larger diameters using a press and a next size bigger sizing die. I think this assumes the bullet is not too hard and alloy, though. A Barnes solid would require a lot of force and possibly need nose and base form-fitting dies to prevent bad distortion. I think the idea of experimenting with electroplating is more likely to prove fruitful.
Gunsite Orange Hat Family Member
CMP Certified GSM Master Instructor
NRA Certified Rifle Instructor
NRA Benefactor Member and Golden Eagle
Unclenick is offline  
Page generated in 0.03402 seconds with 8 queries