The Firing Line Forums - View Single Post

BigJimP · June 7, 2013, 02:38 PM

Not that it matters....but here is my 650 setup on my bench....

http://thefiringline.com/forums/atta...3&d=1262629099

Shop July 08 017.jpg

Dillon 650 ....with case feeder, etc is on one bench. A pair of MEC 9000-HN hydraulic shotshell presses ( the red loaders ) sit beside it on separate benches --- in my basement shop.

I load sitting on a stool ...so loaders are basically at cabinet top height.

June 7, 2013, 02:38 PM	#28
BigJimP Senior Member Join Date: February 23, 2005 Posts: 13,195	Not that it matters....but here is my 650 setup on my bench.... http://thefiringline.com/forums/atta...3&d=1262629099 Shop July 08 017.jpg Dillon 650 ....with case feeder, etc is on one bench. A pair of MEC 9000-HN hydraulic shotshell presses ( the red loaders ) sit beside it on separate benches --- in my basement shop. I load sitting on a stool ...so loaders are basically at cabinet top height.