View Single Post
Old January 22, 2013, 01:14 PM   #1
Senior Member
Join Date: April 4, 2012
Location: South Jersey
Posts: 2,177
re checkering a stock

I have a stock on a sported Mauser that has a nice design but the checkering is shallow and uneven. I would like to go over it and clean it up. I was going to use a 60 degree file but corners will be an issue. How is checkering done and what type of tool would I use?
Concentrated power is not rendered harmless by the good intentions of those who create it.
Milton Freidman
"If you find yourself in a fair fight,,,
Your tactics suck"
- Unknown
BoogieMan is offline  
Page generated in 0.03105 seconds with 8 queries